cladding
CMT, LSC, PMC
Characteristics for overlay welding with low penetration, low dilution and wide
weld seam flow for improved wetting
constant current
PMC
Constant current characteristic
for applications where no arc length control is required (stick out changes are not
compensated)
CW additive
PMC, ConstantWire
Characteristic with constant wire speed progression for the additive production
process
With this characteristic, no arc is ignited, the welding wire is only fed as filler
metal.
dynamic
CMT, PMC, Puls, Standard
Characteristic for deep penetration and reliable root fusion at high welding
speeds
dynamic +
PMC
Characteristic with short arc length for high welding speeds with arc length con-
trol independent of the material surface.
edge
CMT
Characteristic for welding corner seams with targeted energy input and high
welding speed
flanged edge
CMT
Characteristic for welding flange welds with targeted energy input and high weld-
ing speed
galvanized
CMT, LSC, PMC, Puls, Standard
Characteristics for galvanised sheet surfaces (low risk of zinc pores and reduced
penetration)
galvannealed
PMC
Characteristics for iron-zinc coated material surfaces
gap bridging
CMT, PMC
Characteristic for the best gap-bridging ability due to very low heat input
hotspot
CMT
35
EN
To Next Page
Loading...
