Characteristic with hot start sequence, specifically for plug welds and MIG/MAG
spot weld joints
mix
2) / 3)
PMC
Also required:
Pulse and PMC Welding Packages
Characteristic for the production of a rippled weld.
The heat input into the component is specifically controlled by the cyclical pro-
cess change between pulsed and dip transfer arc.
marking
Characteristics for marking conductive surfaces
Characteristic for marking electrically conductive surfaces.
Marking is performed by low power spark erosion and a reversing wire movement.
mix
2) / 3)
CMT
Also required:
CMT drive unit WF 60i Robacta Drive CMT
Pulse, Standard and CMT Welding Packages
Characteristic for the production of a rippled weld.
The heat input into the component is specifically controlled by the cyclical pro-
cess change between pulsed arc or CMT.
mix drive
2)
PMC
Also required:
PushPull drive unit WF 25i Robacta Drive or WF 60i Robacta Drive CMT
Pulse and PMC Welding Packages
Characteristic for the production of a rippled weld by means of a cyclical process
interruption of the pulsed arc and an additional wire movement
multi arc
PMC
Characteristic for components being welded by several arcs each influencing the
other. Ideal for increased welding circuit inductance or mutual welding circuit
coupling.
open root
LSC, CMT
Characteristic with powerful arc, especially suitable for root passes with air gap
PCS
3)
PMC
The characteristic changes directly from a pulsed arc to a concentrated spray arc
above a certain power. The advantages of pulsed and spray arcs are combined in
a single characteristic.
PCS mix
PMC
36
To Next Page
Loading...
