Copyright © 2016 Frontier Communications. All Rights Reserved.
• Connection Type - displays the type of connection
• Physical Address - displays the physical address of the network card
used for the network
• MTU - specifies the largest packet size permitted for Internet
transmissions:
– Automatic - set the MTU (Maximum Transmission Unit) at 1500
– Automatic by DHCP - sets the MTU according to the DHCP
connection
– Manual - allows you to manually set the MTU COAX LINK
1. To set the Channel, select the coax link channel as 1 to 3.
2. Select the On or Off radio button in the Auto Detection field.
3. To set privacy, select the Enabled check box. This causes all devices
connected to the coaxial cable to use the same password. This is
recommended.
4. To set the password, enter the Coax Link password in the Password
field.
5. To enable or disable the Coax link, click Disable or Enable.
6. To view the devices connected using the coaxial cable, click the Go to
WAN Coax Stats link.
BROADBAND ETHERNET/COAX CONNECTION
To Next Page
Loading...
