Copyright © 2016 Frontier Communications. All Rights Reserved.
INTERNET PROTOCOL
1. In the Internet Protocol section, specify one of the following:
• No IP Address – the connection has no IP address. This is useful
if the connection operates under a bridge.
• Obtain an IP Address Automatically – the network connection is
required to obtain an IP address automatically. The server
assigning the IP address also assigns a subnet mask address,
which can be overridden by entering another subnet mask
address.
• Use the Following IP Address - the network connection uses a
permanent or static IP address, then the IP address and
subnet mask address.
2. To override the subnet mask, select the Override Subnet Mask check
box, then enter the new subnet mask.
ROUTING MODE
COMPLETE ALL ETHERNET/COAX CONNECTION CONFIGURATION
UPDATES
To save your changes:
1. Click Apply.
To Next Page
Loading...
