Using ESC/P Emulation
565
Specifications
16
Reduce/Enlarge 54
(reduce/
enlarge
mode)
Sets the magnification for printing an original.
[0] (Default): Preset
[1] : Continuous Magnification
[2] : Fit to Cut Sheet
The preset magnifications are automatically calculated from the set
original size and paper size, to fit the printing area of the original into the
printing area of the paper.Therefore, if the original size and paper size are
the same, this results in 100% (actual size) printing. When two-up is
selected, the printing is such as to fit two pages of the original size in the
printing area of one sheet of paper.
Continuous magnification is the magnification selected with "Reduce/
Enlarge", "Continuous Magnification". The reference point for
magnification is the upper left corner of the printing area. This is the
reference point for all text, images, and graphics.
The whole cut sheet area is printed within the printing area.
Fit to Cut Sheet refer to the magnification automatically calculated from
the set original size and paper size, and means that the physical paper
size of the set original size is printed within the printing area of the paper
size.
17
(Continuous
magnification/
vertical
magnification)
Sets the vertical or horizontal magnification for printing the original.
[0%
Note • When continuous forms are selected for "Original size," both "Preset"
and "Fit to Cut Sheet" produce the same printing results.
18
(Continuous
magnification/
horizontal
magnification)
2 Up Mode 21 Select 2 up printing or printing one page per sheet.Two-up means that
two pages of data are printed on each sheet.Depending on the paper
orientation, the two pages are printed side by side, or one above the
other.
[0](Default): Off
[1] : Forward
[2] : Reverse
Important • When the original size is in landscape orientation, specifying
"Forward" or "Reverse" has the same effect.
Output
Destination
9 Selects the output tray for the printed paper.
[0](Default): Output tray
[80] : Finisher tray (optional)
Tray 5
confirmation
67 When printing from tray 5 (bypass) is specified, printing is started with an
operation on this machine.
[0](Default): Off
[1] : On
Grid lines 22 Selects the method for printing grid lines with two-byte characters.The
options are as follows.
[0] (Default): Image
[1] : Font
Setting item
Item
number
Setting values
To Next Page
Loading...
Need help?
General
