Using CentreWare Internet Services
49
Environment Settings
2
Port Settings (Connectivity)
îš„ Port
You can activate or deactivate communication ports. You can select from SNMP, LPD, and
Port9100. Activate each port by checking its checkbox.
îš„ Apply button
You can apply changes by pressing this button.
Note • Reboot the machine to enable new settings.
Ethernet (Connectivity > Physical Connections)
îš„ Rated Speed
You can set the Ethernet port speed. You can select from Auto, 10 Mbps Half-Duplex, 10
Mbps Full-Duplex, 100 Mbps Half-Duplex, or 100 Mbps Full-Duplex. (Default: Auto)
îš„ MAC Address
The machine's MAC address is displayed.
îš„ Apply button
You can apply changes by pressing this button.
Note • Reboot the machine to enable new settings.
TCP/IP (Connectivity > Protocols)
îš„ IP Mode
You can set the IP operation mode. You can select from Dual Stack, IPv4, or IPv6. The Dual
Stack setting lets you use both IPv4 and IPv6 addresses. (Default: IPv4)
îš„ General
z
Protocol
[Enabled] is displayed.
z
Physical Connection
[Ethernet] is displayed.
z
Host Name
You can set the host name. You can enter up to 32 single-byte alphanumeric characters
or hyphens. (Default: last 16-digit of the MAC address).
Note • Hyphens (-) cannot be used as the first or last character in the string.
z
IPv4
- IP Address Resolution:
You can set the method used to acquire the IP Address, Subnet Mask, and Gateway
Address. You can select from STATIC, DHCP, BOOTP, RARP, or DHCP/Autonet for the
address acquisition method. (Default: DHCP/Autonet)
- IP Address:
You can enter the IP address when [STATIC] is selected for [IP Address Resolution].
- Subnet Mask:
You can enter the subnet mask when [STATIC] is selected for [IP Address Resolution].
- Gateway Address:
You can enter the gateway address when [STATIC] is selected for
[IP Address Resolution].
To Next Page
Loading...
Need help?
General
