150 5 Control Panel Settings
[LPD]
Adobe Protocol Sets the PostScript communication protocol.
• [Normal] (default)
Select this when the communication protocol is in ASCII format.
• [Binary]
Select this when the communication protocol is in binary format. Some data is
printed slower than with the [Normal] protocol.
•[TBCP]
Select this when the communication protocol is both in the ASCII and binary
formats, and switches between the two using control codes.
Note
• Select an appropriate option according to the data format specified on your print
driver.
• [Adobe Protocol] is enabled only when printing in PostScript.
Auto Eject Time Sets the time that data still remaining on your printer is automatically printed and
ejected when data has continuously not been received.
Set the time from 5 to 1275 seconds in 5-second increments. Jobs are judged as
finished when the next data is not received within the time set here, after the last
data has been received. (See *2 on P. 215.)
• [30 Seconds] (default)
Bi-directional Sets whether or not to enable bi-directional parallel communication (IEEE1284).
•[Enabled] (default)
•[Disabled]
Network/Port
LPD
LPD
Port Status
LPD
Print Mode
LPD
PJL
LPD
Connect Time-Out
LPD
TBCP Filter
LPD
Port Number
LPD
Maximum Sessions
LPD
Print Queue
Setting Description
To Next Page
Loading...
Need help?
General
