5.2 Common Menus Setting 153
[Bonjour]
DNS Sets whether or not to use the name registered to the DNS (Domain Name System)
when identifying the printer.
•[Enabled] (default)
The DNS name is used.
•[Disabled]
The IP address is used.
Added Port Number Sets the additional port number from 1 to 65535. (See *2 on P. 215.)
• [80] (default)
Note
• Set only unique port numbers. Note, however, that InternetServices/IPP/SOAP/
UPnP/WSD (See *6 on P. 215) ports and Internet services that use HTTP protocol
can share the same port number.
Connect Time-Out Sets the time after which data reception is canceled if data is not received. Specify
the value from 0 to 65535 seconds in 1-second increments.
• [60 Seconds] (default)
TBCP Filter Sets whether to enable or disable the TBCP filter during processing of PostScript
data.
• [Disabled] (default)
•[Enabled]
Network/Port
Bonjour
Bonjour
Port Status
Setting Description
Port Status Sets whether to enable or disable the Bonjour port at printer start-up.
•[Enabled] (default)
•[Disabled]
Important
• If the printer runs out of memory when the port is enabled, the port is sometimes
automatically disabled. If this happens, either disable unused ports, or change
the memory allocation under [Allocate Memory].
Note
• To use the Multicast DNS feature, set [Enabled]. To use Bonjour to print on the
detector printer, also enable the LPD port.
Setting Description
To Next Page
Loading...
