290 6 Troubleshooting
116-790 No set of the document is stapled.
Check whether the staple position has been correctly specified, and try printing again.
124-702 The output destination was changed because of the malfunction of the specified output tray (Finisher
Tray).
Contact our Customer Support Center. You can use any output trays other than the defective output
tray.
124-705 The punch setting was cancelled.
Confirm the punch position, and then execute the operation again.
124-706 The folding setting was cancelled.
Confirm the folding setting, and then execute the operation again.
124-708 The output destination was changed to the Center tray or Finisher Tray.
The probable causes are as follows:
1 Paper of a different size from the specified is loaded for 2 sided printing.
2 The Punching feature of the Finisher has malfunctioned.
For 1), check whether the specified size paper is loaded in the tray.
For 2), confirm whether the error code 012-231, 012-232, 012-233, or 012-234 is displayed on the
display, and contact our Customer Support Center.
124-709 The document exceeded the maximum number of pages that can be stapled.
Reduce the number of pages, or cancel the stapling setting, and then try printing again.
124-710 The machine cannot output to the output destination specified. A paper size or a paper type that
cannot be output is specified or the output destination fails.
No measure is required. The machine automatically selects the available output destination. If the
paper is not still output from the specified output destination even after the correct paper size and type
is selected, contact our Customer Support Center.
Error Code Cause/Remedy
To Next Page
Loading...
Need help?
General
