6.7 Error Messages and Error Codes 289
116-720 An error occurred during print processing because of insufficient memory.
Stop unnecessary ports or delete unnecessary data to free up disk space.
116-725 Failed to write the image log because the image log storage area on the machine is insufficient.
Execute the operation again.
If this error still is not resolved, take one of the following measures:
• Delete unnecessary image logs.
• Change the [Assurance Level] setting for image logs to [Low].
In this case, selecting [Low] does not secure the contents of created image logs.
116-738 The size and orientation of the form specified are not matched with the paper to be printed.
Match the size and orientation of the paper with the form specified, and print again.
116-739 The form or logo data cannot be registered because memory for the form and logo data or memory
capacity for the hard disk are insufficient.
Delete unnecessary data, or free up the space for the form memory.
116-740 A numerical value operation error occurred because a value exceeding the value limit of the machine
was used in the print data.
Check the print data.
116-741 The form cannot be registered because the number of the form registration exceeds the maximum
number allowed.
Delete unnecessary form. The maximum number allowed is 2048.
116-742 The logo data cannot be registered because the number of the logo data registration exceeds the
maximum number allowed.
Delete unnecessary logo data.
116-743 The logo data or form cannot be registered because the memory for the form and logo data are
insufficient.
Increase memory.
116-746 The form specified is not registered.
Use the form registered, or register the form.
116-747 The paper margin value is too large for the HP-GL/2 active coordinates area.
Decrease the paper margin value, and then execute the operation again.
116-748 There is no plot data in the HP-GL/2 (optional) print data.
Check the print data.
116-749 The job was cancelled because the specified font does not exist.
Install the font, or set the print driver to replace the font.
116-750 Banner sheet tray malfunction
Restore the tray to normal condition or change the Banner sheet tray.
116-751 The process has been canceled because the hard disk is full.
Delete stored data in the hard disk. If the error still is not resolved, split the file and send the job again.
116-752 The descriptions of the PDF or XPS printing job ticket have a problem.
Execute the operation again. If the error still is not resolved, contact our Customer Support Center.
Note
• XPS stands for XML Paper Specification.
116-771
116-772
116-773
116-774
116-775
116-776
116-777
116-778
The data was automatically modified because it included an invalid parameter.
The printed image may be incomplete. Confirm with the sender whether the image has a problem, or
ask the sender to send the data again.
116-780 There is a problem with the document attached to the received e-mail.
Check the attached document.
Error Code Cause/Remedy
To Next Page
Loading...
Need help?
General
