A.5 Installing the HDD Extension Kit 377
3. Press the < > side of the printer's main
power switch to turn off the main power and
close the front cover.
Note
• The <Main Power> lamp goes out on the control panel.
4. Unplug the power cord from the power outlet
and the printer.
5. Loosen the screws on the control board of the
printer.
6. Pull out the handle on the control board and
then carefully pull the control board out of the
printer. Place the control board on a table top
or some other flat surface.
Important
• When pulling out the control board, hold it with both hands
so you do not drop it.
7. With the connector cables of the hard disk
facing outwards, attach the hard disk to the
frame on the control board.
Make sure the protrusions of the hard disk fit
correctly into the slots of the frame.
8. Connect each of the hard disk connector
cables to the connectors on the control board.
To Next Page
Loading...
