CAUTION
CPUs are extremely sensitive to electrostatic discharge and therefore
must always be handled with care.
▶
After a CPU has been removed from its protective sleeve or from its
socket, place it upside down on a nonconducting, antistatic surface.
▶
Never push a CPU over a surface.
Preliminary steps
▶
"Locating the defective server" on page 45.
▶
"Suspending BitLocker functionality" on page 75
.
▶
If applicable, "Removing the front cover with lock" on page 48.
▶
"Shutting down the server" on page 48.
▶
"Disconnecting the power cord" on page 49.
▶
"Getting access to the component" on page 52.
Removing the LC kit
▶
Remove the riser module 3 with the tubes, see "Removing a riser module"
on page 69.
Figure 207: Removing the cable clip and protective caps
Liquid cooling (LC)
300 Upgrade and Maintenance Manual RX2530 M6
To Next Page
Loading...
