Fujitsu PRIMERGY RX4770 M6 - Page 153

Preliminary steps
▶
"Locating the defective server" on page 97
.
▶
If applicable,"Removing the front cover with lock" on page 45.
▶
"Shutting down the server" on page 46.
▶
"Disconnecting the power cord" on page 47.
▶
"Getting access to the component" on page 48.
▶
"Removing the air duct 1 (top system board)" on page 68.
▶
"Removing the fan cage" on page 64.
▶
If applicable, remove the ODD, see "Removing the ODD" on page 308.
▶
Release all HDD/SSD modules and pull them out a few centimeters, see
"Removing 2.5-inch HDD/SSD modules" on page 145.
CAUTION
The HDD/SSD modules need not to be removed.
▶
If you want to remove them nevertheless, check if all HDD/SSD
modules are uniquely identified so that you can reinsert them
into their original bays.
Removing the ODD cage
▶
Remove the ID card.
▶
Remove the ODD, see "Removing the ODD" on page
308.
Hard disk drive (HDD) / solid state disk (SSD)
RX4770 M6 Upgrade and Maintenance Manual 153