SECTION 8: Specifications and Safety
2025653-048 Revision B Responder
™
2000 Page 102
Physical Dimensions
Height: 10.8 inches/27.4 cm
Width: 11.7 inches/29.7 cm
Depth: 7.4 inches/18.8 cm
Weight: Less than 10lbs/4.5kg, excluding battery, paddles, and a full roll of paper.
Environmental Requirements
Operating Conditions
Temperature: 0°C to 50°C (32 °F to 122°F)
Humidity: 10% to 95% RH, non condensing
Air Pressure altitude: -500 ft (103kPa) to 15000 ft (57kPa)
Storage and Shipping Conditions
Temperature (Responder 2000): -20°C to 60°C (-4°F to 140°F)
Temperature (Pads): -12°C to 43°C (10°F to 110°F) for 2 years.
NOTE: Do not exceed 38°C (100°F) for periods greater than 6 months in duration. Always store the pads in their pouch to
maintain freshness. Do not use if gel has dried out.
Humidity: 10% - 95% RH, non-condensing
Air Pressure altitude: -500 ft (103kPa) to 15000 ft (57kPa)
WARNING:
Electrode performance may be adversely affected by pre-attaching and storing with defibrillator cable or exposure to air
for long periods of time. These electrodes are not recommended for electrosurgery.
CAUTION: Environment of use
Responder 2000 is designed for indoor use. Operator must confirm that the environment of use meets the required
operating environmental specifications before using.
CAUTION: Cold Environments
If the Responder 2000 is stored in an environment with a temperature below the operating temperature, the unit should be
allowed to warm up to the needed operating temperature before using.