SECTION 2: Maintenance
2025653-048 Revision B Responder
™
2000 Page 16
Upgrade Printer Software
When installing the printer software, the files must be upgraded in the following order without reboot:
• printerflash.bin
• printerfont.bin
• printerflash.bin again
Caution: Procedure Failure.
The printer files must be updated without reboot. If the unit is rebooted during the installation, the printer may not work
(the Main Board firmware must then be reinstalled at a repair center).
1. Perform the Equipment Setup procedure starting on page 13 until the CodeLink 2000 selection window is
displayed:
2. Click Choose file to select a single update file.
3. Navigate to the Printer folder and select the printerflash.bin file.
4. Click Open. While the file is updating, the status of the file is displayed.
As the file is updated, the Shock button and then the Manual button flash on the Responder 2000.
5. When the file is updated, a confirmation screen is displayed:
6. Verify Pass is displayed for the file and click OK.
Note: If the file fails to update, try updating the file again.
The Upgrade Complete Notification is displayed:
7. Click Yes and repeat this procedure for the printerfont.bin file and then the printerflash.bin again.
8. Click Exit.
9. Verify the file upgrade on the Responder 2000.
a. Press and hold the Power button for 5 seconds to reboot the Responder 2000.
b. Highlight and click the System Menu.
c. Click About.
d. Click Next to scroll through to the printer version screen. Verify the Printer and Font software versions are
updated as listed in the Version.txt file.
To Next Page
Loading...
Need help?
General
