SECTION 2: Maintenance
2025653-048 Revision B Responder
™
2000 Page 14
Upgrade Software
Caution: Procedure Failure
Do not use this procedure to update the printer files. Updating the printer files incorrectly may cause the printer to fail. Use
the Upgrade Printer Software procedure on page 16.
1. Perform the Equipment Setup procedure starting on page 13 until the CodeLink 2000 selection window is
displayed:
2. Click Choose folder to select all the update files in a folder or Choose file to select a single update file.
3. Browse to the folder (or file) to be uploaded and click OK (or Open). While the files are updating, the status of
each file is displayed.
As the files are updated, the Shock button and then the Manual button flash on the Responder 2000. When all
files are updated, a confirmation screen is displayed
4. Verify Pass is displayed for each file and click OK.
Note: If a file fails to update, retry updating the file individually.
The Upgrade Complete Notification is displayed:
5. Click Yes to upgrade more files (and repeat this procedure from step 2) or No to exit.
To Next Page
Loading...
Need help?
General
