What to do if my GE Analytical Instruments displays an iButton Read Error?
Please power cycle the Analyzer. If the problem persists, consult the Operation and Maintenance Manual for further instructions.
How to resolve Operating System Error on GE Analytical Instruments?
This is a 'catch all' for any errors not specifically defined elsewhere. Please power cycle the Analyzer. If the problem persists, export errors and contact GE Analytical Instruments for further instructions and analysis.
What to do if my GE Analytical Instruments displays a Heater Error?
Please power cycle the Analyzer. If the problem persists, export errors and contact GE Analytical Instruments for further instructions and analysis.
What to do if my GE Analytical Instruments displays a Syringe Position Error?
Please power cycle the Analyzer. If the problem persists, export errors and contact GE Analytical Instruments for further instructions and analysis.
How to fix Power Error on GE Analytical Instruments?
Please power cycle the Analyzer. If the problem persists, export errors and contact GE Analytical Instruments for further instructions and analysis.
What should I do if my GE Analytical Instruments displays Stream 5 Flow Warning?
Check that water is flowing in the sample cup and the inlet valve (if installed) is properly adjusted. If the problem persists, please export the warnings and contact GE Analytical Instruments for further instructions.
How to resolve Software Control Error on GE Analytical Instruments?
Please power cycle the Analyzer. If the problem persists, export errors and contact GE Analytical Instruments for further instructions and analysis.
What should I do if my GE Analytical Instruments displays Stream 3 Flow Warning?
Check that water is flowing in the sample cup and the inlet valve (if installed) is properly adjusted. If the problem persists, please export the warnings and contact GE Analytical Instruments for further instructions.
What should I do if my GE Analytical Instruments displays Stream 2 Flow Warning?
Check that water is flowing in the sample cup and the inlet valve (if installed) is properly adjusted. If the problem persists, please export the warnings and contact GE Analytical Instruments for further instructions.
What should I do if my GE Analytical Instruments displays Stream 1 Flow Warning?
Check that water is flowing in the sample cup and the inlet valve (if installed) is properly adjusted. If the problem persists, please export the warnings and contact GE Analytical Instruments for further instructions.
General| Category | Measuring Instruments |
|---|---|
| Brand | GE |
| Model | Sievers Innovox |
| Response Time | Typically 2 minutes |
| Power Supply | 100-240 VAC, 50/60 Hz |
| Communication Interfaces | USB, Ethernet |
| Certifications | CE |
| Humidity Range | 10% to 90% non-condensing |
Provides detailed technical specifications for the InnovOx TOC Analyzer.
Discusses sample species that can form toxic products or react violently.
Details interferences that can affect component longevity and performance.
Explains how inorganic compounds can affect measurement accuracy.
Procedure for connecting the waste tube to a drain.
Details on connecting various cables and I/O interfaces.
Instructions for safely connecting the analyzer to AC power.
Guidance on connecting sample streams to the analyzer.
Procedures for installing the wastewater sampler.
Guides initial power-up and basic analyzer configuration.
Procedure to confirm the analyzer is operating correctly.
Step-by-step guide to performing the calibration process.
Instructions for reviewing and modifying calibration measurements.
Defines measurement settings for Online, Check Standard, Grab, and Rinse modes.
Guides on setting up online measurements for various features.
Details parameters for NPOC, TOC, TC, and IC measurements.
Procedure for measuring carbon concentrations in reagents for blank correction.
Guides on configuring analyzer interfaces and connections.
Steps to manually configure IP settings for network connection.
Safe procedures for powering down the analyzer.
Procedure for lubricating the analyzer's syringes every three months.
Six tests to locate leaks in the gas delivery system.
Correction for carbon contribution from reagents.
To Next Page
