GE HEALTHCARE
DIRECTION FQ091013, REVISION 1 VIVID I N AND VIVID Q N SERVICE MANUAL
Chapter 3 - System Setup 3-101
6.) Click Check to verify the connection.
3-10-3-6-1 Configuring the Repository Remote Path
NOTE: It is possible to configure an additional user name and password for all remote paths. These settings
are only used if the system fails to log on the default user and password.
• Under Configurable Remote Path User (refer to Figure 3-103), type the desired user name and
password, as configured on the destination PC.
(This is the password usually assigned by the local IT person).
3-10-3-7 Save the New Settings
1.) Press SAVE SETTINGS
to save the new settings.
.
The new settings are saved to a common settings file. After a restart, the settings are also included
in other screens.
2.) Restart the Vivid i n/ Vivid q N system to activate the changes.
Figure 3-104 Save New TCP/IP settings
Save settings
To Next Page
Loading...
