GE HEALTHCARE
DIRECTION FQ091013, REVISION 1 VIVID I N AND VIVID Q N SERVICE MANUAL
3-100 Section 3-10 - Connectivity Setup
3-10-3-5 Vivid i n/ Vivid q N Remote Path Configuration
The Vivid i n/ Vivid q N Remote Path feature enables the user to define an additional user name, other
than the default "E1c2h3o4C5l6i7e8n9t".
3-10-3-6 Configuring the Vivid i n/ Vivid q N Remote Path
NOTE: Before starting this procedure, verify that the destination PC / Network has a Shared folder
(remote path) with user permissions. Refer to section 3-10-9-1-1 on page 3-137 for creating a
new user in the remote PC or network.
NOTE: The paths below (refer to Figure 3-103) are used as follows:
• Save As PDF Network Path - used for saving system Reports as PDFs.
• Remote Path - used for Save As, Export from Q-Analysis, and for
exporting error logs with "Alt + D".
1.) From the system keyboard press Config and log on as an ADM user with the appropriate password.
2.) Click Connectivity (from the bottom row of buttons) on the screen and select the Tools tab.
The Tools screen opens - see Figure 3-103.
3.) Under "Save As PDF Network Path", in the Remote Path field, type the remote path.
For example, in Figure 3-103 type: \\IP ADDRESS\DIRECTORY, where directory is the name of
the shared folder in the destination PC.
4.) Click Check to verify the connection.
NOTE: When clicking the Check button, you might momentarily see a "failed" message that disappears
if you click Check a second time. The system will then confirm the setting.
5.) Under "Setting for Remote Path used for Save As...", type the remote path as follows:
\\IP ADDRESS\DIRECTORY.
Figure 3-103 Tools Screen
Save AS PDF Network Path
Remote Path
Configurable Remote Path User
To Next Page
Loading...
