GE Vivid i n - Page 274

GE HEALTHCARE
DIRECTION FQ091013, REVISION 1 VIVID I N AND VIVID Q N SERVICE MANUAL
4-26 Section 4-3 - Functional Checks
If applicable, proceed to run the Respiratory Test, as
described below.
8
Activate the Respiratory radio button.
The Respiratory signal is displayed in the Data area, as
shown in the example below:
9
Verify that a single clear Respiratory signal is displayed.
10
When done, trackball to the Exit button and press Set.
11
When prompted by the following message, select Yes or
No as applicable.
12
Press the <Esc> button on the keyboard to close the
Diagnostic Test window.
13
When done, press Exit button
Table 4-12 ECG/Respiratory Test - Recommended
Step Task Expected Result(s)