GE HEALTHCARE
DIRECTION FQ091013, REVISION 1 VIVID I N AND VIVID Q N SERVICE MANUAL
Chapter 8 - Replacement Procedures 8-33
8-3-2-4 TR32 and RFI Boards Removal Procedure
1) Remove the bearing handle, as described in the Bearing Handle Removal Procedure on page 8 - 3.
2) Remove the Control Panel and Keyboard, as described in the Control Panel and Keyboard
Removal Procedure on page 8 - 9.
3) Loosen the eight screws that secure the TR32 and RFI Boards to the Bottom Assembly, as shown
in Figure 8-37 below.
4) Remove the eight screws - see Figure 8-38.
5) Disconnect the PCI cable flex (BEP-to-RFI) from the cable connector on RFI Board as shown in
Figure 8-37 Loosen Screws that Secure TR32 and RFI Boards to Bottom Assembly
Figure 8-38 Removing the Screws
To Next Page
Loading...
