GE HEALTHCARE
DIRECTION FQ091013, REVISION 1 VIVID I N AND VIVID Q N SERVICE MANUAL
8-78 Section 8-4 - SafeLock Cart Components Replacement
NOTE: The movement should be smooth and there must be no pinching of the cables.
Slide the top-shelf up and down a number of times and check that the cables do not disturb the up-down
movement of the cart’s top-shelf - see Figure 8-92.
12.)Return the Upper Rear Cover as described in Service Manual Direction R2423163-100, Revision
3, Chapter 8, section 8-4-3-4.
13) Return the Upper Cover (rear) and Lower Cover (rear) of the SafeLock Cart as described in Upper
Cover (Rear) Installation Procedure on page 8 - 64 and Lower Cover (Rear) Installation Procedure
on page 8 - 71.
14.)Once more, slide the top-shelf up and down a number of times and check that the movement is
smooth and that there is no interference of the cables with the up-down movement of the cart’s
top-shelf.
15) Proceed to perform the following functionality tests:
- SafeLock Cart - Grounding Continuity on page 10 - 23
- SafeLock Cart - Chassis Current Leakage Test on page 10 - 25
Figure 8-92 Fully-raised (left) and Fully-lowered Positions (right)
To Next Page
Loading...
