GE HEALTHCARE
DIRECTION FQ091013, REVISION 1 VIVID I N AND VIVID Q N SERVICE MANUAL
Chapter 8 - Replacement Procedures 8-117
11) Press <F10> to Exit Saving Changes as shown in Figure 8-122.
12.)Reboot the system and check that the Supervisor PASSWORD was installed properly.
13.)Proceed to perform the following functionality tests:
- Software Configuration Checks on page 4 - 37
- Calibration Tests on page 7 - 25
- Full System Test on page 7 - 10
Figure 8-122 BIOS Exit Screen
To Next Page
Loading...
