How to fix a GRAPHTEC FC7000 when the power lamp doesn't light?
If the power lamp on your Graphtec Plotter's control panel isn't lighting up and the LCD is blank, first ensure the power cord is securely connected to both the plotter's AC line inlet and the electrical outlet. If the issue persists, it may indicate a defect with the plotter.
Explains the ranking and use of safety precautions in the manual.
Details the meaning of danger, warning, and caution symbols.
Lists critical warnings and precautions for safe operation and handling.
Provides disclaimers and notes on manual content and reproduction.
Lists trademarks and registered trademarks of companies.
States the copyright ownership of the manual.
Lists standard accessories included with the plotter for verification.
Identifies and describes the main components of the plotter's front and rear views.
Provides step-by-step instructions for assembling the plotter unit and stand.
Describes various cutter blades, their part numbers, and applications.
Provides instructions on how to remove and replace a cutter blade.
Explains how to adjust the blade extension for optimal cutting depth.
Describes the plotter's control panel, indicator lamps, function keys, and position keys.
Provides step-by-step instructions for loading roll and sheet media into the plotter.
Guides on positioning pinch rollers correctly relative to media width and grit rollers.
Lists optimal cutting conditions (force, speed, quality) for various media types.
Details how to adjust FORCE, SPEED, QUALITY, and OFFSET parameters.
Explains how to perform test cuts to verify and optimize cutting settings.
Explains how to temporarily suspend and resume a cutting or plotting operation.
Explains how to advance media for acclimation and prevent slipping.
Guides on setting a new origin point for the plotting area.
Defines the effective area for cutting or plotting by specifying upper-right and lower-left points.
Uses sensor to read marks and adjust axes for precise cutting on pre-printed media.
Provides procedures for compensating for offsets or tilts in coordinate axes.
Accessory used for precise alignment during axis operations and plotting area setup.
Assigns physical pens (PEN 1, PEN 2) to condition setting areas for 2-pen models.
Lists and describes various special functions and background settings available.
Provides procedures for displaying and modifying background settings via menus.
Provides troubleshooting steps for power-related operational issues.
Offers solutions for various operational malfunctions and errors.
Lists common cutting issues and their corresponding solutions.
Details the requirements and settings for using the RS-232C serial interface.
Provides instructions for using the USB interface and supported operating systems.
Configures transmission speed, data length, parity, and handshaking for RS-232C.
Presents a detailed table of the plotter's technical specifications across models.
Shows diagrams and dimensions of the plotter with and without optional stand.
To Next Page
General