• Automatic Sequential
If switches assigned to the REPEAT and TRIGGER
lines are activated, all the announcements includ-
ed in this menu and its submenus will be repeat-
ed within the time interval selected in the REPEAT
line:
BACK
REPEAT
TRIGGER
TRANSMITTER
GENERAL MOD
VARIO MOD
10s
SW 3
>>
>>
>>
ESC MOD
SW 2
>>
NULL
>>
>>
>>
INC
RES
DEC
VARIO
RECEIVER
ELEC MOD
GPS MOD
AUTO
TONE
Telemetry
VARIO
If the SENSOR submenu VARIO line is ON (page
113), the switches assigned to this line can be used
to retrieve vario-specific voice triggers such as "slow-
ly ascending/descending" through the transmitter's
headphones independent of the other voice triggers,
i.e., voice triggers triggered by a change in height.
BACK
REPEAT
TRIGGER
TRANSMITTER
GENERAL MOD
VARIO MOD
10s
NULL
>>
>>
>>
ESC MOD
NULL
>>
NULL
>>
>>
>>
INC
RES
DEC
VARIO
RECEIVER
ELEC MOD
GPS MOD
AUTO
TONE
Telemetry
Press
Refer to the Control and Switch Assignment section
(page 26) for information on how to assign switches.
TRANSMITTER
Press the bracket button in the TRANSMITTER line:
BACK
REPEAT
TRIGGER
TRANSMITTER
GENERAL MOD
VARIO MOD
10s
NULL
>>
>>
>>
ESC MOD
NULL
>>
NULL
>>
>>
>>
INC
RES
DEC
VARIO
RECEIVER
ELEC MOD
GPS MOD
AUTO
TONE
Telemetry
Press
The transmitter display opens:
BACK
TX-VOLT
MODELTIME
BATT TIME
TIMER 1
TIMER 2
CURR. TIME
Telemetry
Use this submenu to activate and deactivate the voice
triggers available for each selection in the value fields:
BACK
TX VOLT
MODELTIME
BATT TIME
TIMER 1
TIMER 2
CURR. TIME
Telemetry
Press
RECEIVER
Press the bracket button in the RECEIVER line:
BACK
REPEAT
TRIGGER
TRANSMITTER
GENERAL MOD
VARIO MOD
10s
NULL
>>
>>
>>
ESC MOD
NULL
>>
NULL
>>
>>
>>
INC
RES
DEC
VARIO
RECEIVER
ELEC MOD
GPS MOD
AUTO
TONE
Telemetry
Press
The receiver display opens:
BACK
TEMP
STRENGTH
RX VOLT
L-VOLT
Telemetry
Use this submenu to activate and deactivate the voice
triggers available for each selection in the value fields.
Sensors
The displays for selecting sensor-specific voice trig-
gers should only be opened when the sensors con-
nected to the receivers are recognized after the re-
ceiver is switched on. Three corresponding voice
triggers are selected as described above.
117
Function menu - Telemetry | Voice Trigger
To Next Page
Loading...
