Once the parameters are established in the FUNC-
TION submenu Logical sw display, assign the logical
switches to a switch. In many submenus there is a
CTL option. By pressing any CTL field the following
active window will appear:
Select
CLR
NO
LOGIC
Press
Pressing the LOGIC button will bring up the logical
switch menu:
L1
L5
L2
L6
L3
L7
L4
L8
BACK
Select logical switch
L1i
L5i
L2i
L6i
L3i
L7i
L4i
L8i
Press the logical switch to assign to the related value
field.
Tip
Selecting an inverted switch, e.g. "L3i" instead of "L3",
note that only the switch direction of this specific switch
will be reversed and not the logical switch itself!
If a specific “L” switch activates a function (i.e. a timer),
the “i” (inverted) setting will activate the function regard-
less whether the switch is in the ON or OFF position.
Therefore, a possible use-case scenario might include
using the same switch to activate one function while de-
activating another function and vice versa.
149
Function menu | general - Logical switches
To Next Page
Loading...
