GRAUPNER mz-24 PRO - Page 221

Vertically, the right stick is exemplary located on a
randomly inclined position in the direction of the pilot
(due to its non-self-centering characteristic as a CH1
control stick).
Before tapping the SET button on the right, the right
control stick, which in this example is not self-center-
ing, should be moved to the mechanical center:
Stick Cali
BACK
<< RIGHT >>
VERTI.
HORIZ.
–001%
+002%
SET
As soon as this placement is achieved, press the SET
button at the right edge of the display:
Stick Cali
BACK
<< RIGHT >>
VERTI.
HORIZ.
–001%
+002%
SET
Press
The neutral position of the right control stick is then
calibrated, and the blue dot moves to the left, top cor-
ner of the grid:
Stick Cali
BACK
<< RIGHT >>
VERTI.
HORIZ.
000%
000%
SET
Move the right control stick to the front left corner
without exerting pressure at the limit. If the transmitter
is incorrectly adjusted, the results can have the fol-
lowing result:
Stick Cali
BACK
<< RIGHT >>
VERTI.
HORIZ.
+102%
+098%
SET
Press the SET button at the right edge of the display
to transfer the 100% position to the memory; the se-
lected dot then switches to the opposite corner:
Stick Cali
BACK
<< RIGHT >>
VERTI
HORIZ
+100%
+100%
SET
Use the same calibration procedure for the opposite
corner; the display screen will change color and posi-
tioning for left control stick calibration:
Stick Cali
SET
BACK
<< LEFT >>
VERTI.
HORIZ.
+001%
–002%
Use the same calibration procedure for calibrating the
left control stick.
Notice
If the calibration of any of the control sticks is off
or incorrect in any way, the entire process will
have to be repeated.
Press BACK to return to the SYSTEM menu.
BACK
SYSTEM
BASE
FUNCTION
ST mode
Etc. Set
Warning
Display
MP3
Stick Cali
221
System menu - Joystick calibration