GRAUPNER mz-24 PRO - Page 231

Continue to set all flaps in each phase in the same
manner.
Lastly, determine the proportional entrainment of the
elevator via the mixing value and the mixing direction
of the mixer CH6 >> CH3, as shown below:
BACK
PHASE 1
SERVO
Prog.MIX
CH6
A
OFFSET X
CTL
ON
000%
INC
RES
DEC
000%
CH3
>>
ACT
ON
B
OFFSET Y
+025%
+025%
ON
TRIM
OFFSYM
231
Programming example - Flaps trimming