GRAUPNER mz-24 PRO - Page 67

row keys ( pq ) to the left of the display screen to
achieve the same result. This adjustment allows the
motor or engine to run at the desired idle speed or
switches the engine or motor off:
The adjustment range is ±150%.
BACK
ACT
CTL
SET
DEC
PHASE 1
RES
INC
Sv
ON
INH
Thr.CUT


–123%
Notice
With an ICE, make sure that the throttle servo
does not mechanically over-travel.
Assign the required ON/OFF switches (such as
SW6)to the CTL line as described in the Control and
Switch Assignment section (page 26):
BACK
ACT
CTL
SET
DEC
PHASE 1
RES
INC
SERVO
SW 6
INH
Thr.CUT


–123%
Press to change the field in the ACT line. Depending
on the switch position, the display of this field switch-
es to ON or OFF.
BACK
ACT
CTL
SET
DEC
PHASE 1
RES
INC
SERVO
SW 6
ON
Thr.CUT


–123%
To advance directly to the BASE submenu Servo dis-
play, press the SERVO button in the top right corner
of the screen. Alternatively, simultaneously press the
arrow keys ( pq ) to the left of the display (while no
fields are highlighted) to also bring up the Servo dis-
play.
Press the BACK button to return to the BASE menu
display:
BACK
ACT
CTL
SET
DEC
PHASE 1
RES
INC
SERVO
SW 6
ON
Thr.CUT


–123%
Press
67
Base menu - Motor stop