Harmonic ProView 7100 - Page 118

Chapter 7 Device Configuring Using EMS Multiplex & Decoding Outputs
© 2012 Harmonic Inc. 118 ProView 7000 v.2.6, Rev. E
7.3.8.4 Audio 1/2 Parameters Tab
The Audio 1/2 parameters tab provides the EMS user the following information and set-up
capabilities:
General Audio processing parameters:
■ Decoding Codec – selects the audio decoding mode.
Options:
❑ Automatic
❑ Musicam
❑ Dolby Digital
11
(AC-3)
❑ Dolby Digital (AC-3) Pass Through
❑ Dolby Digital Plus
11
(E-AC-3) – (Audio 1 channel only)
❑ DD+ (E-AC-3) to DD (AC-3) Pass Through – (Audio 1 channel only)
❑ AAC LC – (Audio 1 channel only)
❑ HE AAC – (Audio 1 channel only)
❑ Dolby E
11
/ Linear PCM Pass Through – (Audio 2 channel only)
■ Volume – sets the audio volume.
Range: −64 to 0 dB
■ Delay – the delay.
Range: −128 to +128 msec.
■ Analog Mixer – selects the mixing L/R inputs to outputs.
Options:
❑ Stereo
❑ Mono
❑ Both Left
❑ Both Right
■ Digital Format – selects the audio format mode.
Options:
❑ Professional
❑ Consumer
11. Dolby, Dolby E, Dolby Digital and Dolby Digital Plus are registered trademarks of Dolby Laboratories.