Harmonic Spectrum X - Spectrum X SDI I;O Connectors: Standard Channel Mode

Chapter 4: Spectrum X hardware reference
Table 4-5: Enhanced Channel configuration 3 (EC3)
Connector Description Connector Description
I/O 1 Ext In 1/Key 1 I/O 5 Ext In 4/Key 2
I/O 2 Ext In 2/Fill 1 I/O 6 Ext In 5/Fill 2
I/O 3 Ext In 3 I/O 7 Ext In 6
I/O 4 Out, Primary I/O 8 Out, Secondary
UHD configuration
NOTE: In UHD mode, both SDI cards on the Spectrum X are used for one channel of
UHD. SDI card 1 refers to the card on the left-hand side when facing the rear panel. SDI
card 2 refers to the card on the right-hand side when facing the rear panel.
Table 4-6: UHD configuration (UC1)
Connector,
SDI card 1
Description Connector,
SDI card 2
Description
I/O 1 External input 1 I/O 1 External input 2
I/O 2 External input 1 I/O 2 External input 2
I/O 3 Out, Primary I/O 3 Out, Secondary
I/O 4 Out, Primary I/O 4 Out, Secondary
I/O 5 External input 1 I/O 5 External input 2
I/O 6 External input 1 I/O 6 External input 2
I/O 7 Out, Primary I/O 7 Out, Secondary
I/O 8 Out, Primary I/O 8 Out, Secondary
Spectrum X SDI I/O connectors: standard channel mode
The Spectrum X uses DIN 1.0/2.3 connectors for its SDI I/O connections. The connectors have specific
functionality when the Spectrum X is in standard channel mode.
Refer to the figure and the table for information on the different SDI I/O connections when the Spectrum X
is in standard channel mode.
Figure 4-6: Spectrum X SDI I/O connectors: standard channel
106