Harmonic Spectrum X - Channelport 8200 Rear Panel: Enhanced Channel Mode

Chapter 8: ChannelPort module hardware reference
Key Component Description
16 RS-422 Port and LEDs Use this connector (RJ-45) for RS-422 serial
control. The LED at the top left of the port
indicates channel activity.
17 Gigabit Ethernet Port Not applicable for systems running 8.4 and later
software; only systems running 8.3.x.x and earlier
software use this port.
18 Gigabit Ethernet Port Used only in MediaPort 7000.
Related information
About MediaPort 7000 and ChannelPort timing on page 156
GPIO/RS-422 connector signal assignments on page 181
ChannelPort 8200 rear panel: Enhanced Channel mode
Review to the diagram and the table for details on the rear panel component functionality when
theChannelPort 8200 is in Enhanced Channel mode.
NOTE: Connections 1 - 8 on ChannelPort 8200 modules use DIN 1.0/2.3 connectors.
Figure 8-3: ChannelPort 8200 rear panel (Enhanced Channel mode)
Key Component Description
1 External Input 1/External
Key Input 1
Use for video input or External Key input 1.
Refer to “Enabling Enhanced Channel mode” in
the Harmonic SystemManager User Guide for
instructions on configuring Enhanced Channel
mode to enable Key/Fill.
Refer to the Spectrum X and ChannelPort
Template Authoring Guide for information on
External Key/Fill.
176