3. Withdraw the envelope from the WP and insert it into the mail path against the
rear-guide wall, with the side to be printed facing upwards.
If a mail piece is bigger than mail path maximum thickness (see
Mail Specifications on page 237 ), press to print a label. The
label is printed.
4. The Mailing System prints postage and the mail piece (or label) is sent to the catch
tray.
When using sealer, collect the mail piece stack in the catch tray
and put stack aside to let envelopes dry.
If you want to print several identical labels :
1.
Press and enter the number of labels.
Make sure the labels are available in the label dispenser (see Filling the Label
Dispenser on page 76 ).
2.
Press to print the labels.
46
| Page 46 | feb-14-2014 12:06 |
3
Processing Mail
To Next Page
Loading...
