3.
The Mailing System applies postage and the mail piece (or label) is sent to the catch
tray.
When sealer is activated, collect the mail stack in the catch tray
and put stack aside to let envelopes dry.
To print several identical labels :
1.
Press and enter the number of labels.
Make sure the labels are available in the label dispenser (see Filling the Label
Dispenser on page 76 ).
2.
Press to print the labels.
Re-dating Mail
Set-Up Requirements
The procedure below outlines steps required to re-date mail that has already been
processed.
The sequence is similar to sequence Applying Standard Postage on page 41, except for
the following settings:
•
Postage must be set to zero and have the date of mailing correct
•
You do not have to weigh the mail piece.
•
Print the new date on the back of the envelope.
You must begin by selecting the Type of stamp to gain access to the corresponding
parameters and be able to run mail.
Make sure you have already completed the preparation steps
mentioned in Preparing and Starting your Work Session on page
31 .
3
Processing Mail
49
| Page 49 | feb-14-2014 12:06 |
To Next Page
Loading...
