In optional mode Differential Weighing auto-tape ( )
From the [Standard ] home screen:
1. Place the stack of mail you want to process on the weighing platform, and then follow
the instructions on the screen or the steps below.
2. Withdraw the first mail piece from the top of the stack. The Mailing System displays
weight and postage on the home screen, starts motors and prints the label
automatically.
If you inadvertently remove more than one item from the WP,
replace removed items on WP before weight stabilization to
avoid printing label (about 1.5 seconds).
3. Repeat the previous step for each piece of mail.
To quit the process at any time, press .
When you remove the last object from the Weighing Platform,
the Mailing System will ask if you want to print it. You can answer
Yes or No.
In other modes (Manual weight entry , no weight ...)
From the [Standard ] home screen:
1.
Press . System motors start running.
2. Insert the mail piece into the mail path against the rear-guide wall, side to be printed
facing upwards.
If a mail piece is bigger than mail path maximum thickness (see
Mail Specifications on page 237 ), press to print a label. The
label is printed at once.
48
| Page 48 | feb-14-2014 12:06 |
3
Processing Mail
To Next Page
Loading...
