65
Table 5-3: Installation tools
Types Item Description
Common
tools
Wire strippers For Power Supply and for I/O
Wiring
Crimper For Terminal Lugs on Power
Supply wiring and on I/O wiring
shields
Screwdrivers Small flat-tip For Euro-style Terminal Blocks
Small/medium flat-tip or #2
Phillips or 3/16 inch slotted
screwdriver
For Barrier style Terminal blocks;
also for captured screws in
Terminal Blocks
Large (long blade) For use as I/O Module extractor
Other Electric drill, with drill bits for
#10 or M4 screws, and with drill-
bit extender
For rack mounting
Vacuum cleaner, brush For use during and after drilling
operations
Pen, ball-point or felt-tip, for
entering data on labels for I/O
modules)
For entering data on labels for I/O
modules
Multi-Meter (Volt/Ohms/Amps) For safety checks and for
equipment test
Soldering pencil or gun (for
attaching filter capacitors to I/O
wiring shields)
For attaching filter capacitors on
I/O wiring shields
Preparing the installation site
Table 5-4: Site and equipment preparation
Step Procedure
For more
information, see
1 Racks (4-, 8- and 12-slot) Mount racks section.
2 Install (or verify correct installation of) enclosures for
CPM and ancillary equipment:
Mount racks section
Installing I/O
To Next Page
Loading...