Honeywell HC900 - Page 228

Appendix - Installation of Remote Termination Panels (RTPs) - Relay Output
216 HC900 Process Controller Installation and User Guide Revision 19
06/14
Relay Output
Step Action
4 Connect field wiring.
1 2
3 4
5
6 7
8 9 10
11 12 13
14 15
16
17 18 19
20
DO-8
DO-7
DO-6
DO-5
DO-4
DO-3
DO-2
DO-1
LOAD NO
LOAD NC
LOAD NO
LOAD NC
LOAD NO
LOAD NC
LOAD NO
LOAD NC
LOAD NO
LOAD NO
LOAD NO
LOAD NO
ATTENTION
• Cable power is limited to 24 Amps per module at 60C (140 degrees F) and 32 Amps at 54C
(129 degrees F).
• As shown in the schematic, each switch is SPST and opens and closes one lead of the relay
wiring. If your application requires opening and closing both sides of the load wiring, then an
external DPST switch is required.