Required Equipment
The equipment needed to install the HP 4062 follows:
Standard Screwdriver (one large, one small)
Phillips Screwdriver
Wire Stripp ers
Slip-joint Pliers
Battery-p owered Voltmeter
Utility Software
The system software contains the following utilities for checking the installation pro cess:
PROBER program Checks your prob er operations after installing the HP 4062UX/F system.
For details, see the following les:
/usr/pcs/etc/prober_check/READ_ME
check62ux A shell pro cedure that checks the system software installation of the HP
4062UX/F.
Abbreviations
Throughout the HP 4062UX/F do cumentation, the following abbreviations are used to
identify the subsystems and instruments in the HP 4062UX/F system.
Abbreviation Term
SMS Switching Matrix Subsystem: consists of SWC and SWM
SWC HP 4084B Switching Matrix Controller
SWM HP 4085B, HP 4089B, or HP 4085F Switching Matrix
DCS DC Measurement Subsystem: HP 4142B Mo dular DC Source/Monitor
CMS Capacitance Measurement Subsystem
CMU Capacitance Measurement Subsystem: HP 4280A 1 MHz C Meter/C-V Plotter
CMU84 Capacitance Measurement Subsystem: HP 4284A 20 Hz{1 MHz Precision LCR
Meter
PCS Pro cess Control System
PDU Power Distribution Unit
BASIC/UX BASIC on HP-UX: the HP BASIC co ordinated to execute on HP-UX system
General Information 1-3
To Next Page
Loading...