HP 4062UX - System con Guration Error; Errors During the PV4062;PV4062.F Program; Error Occurs While Test Infomation of File Is Being Stored

Possible Cause Solution
/usr/pil/etc/hwcong.cf or
/usr/pcs/etc/SYSCONFIG les are set
incorrectly.
Check the settings in the /usr/pil/etc/hwcong.cf
or /usr/pcs/etc/SYSCONFIG les. Then p erform
/usr/pil/bin/pilconf command again. For details
ab out settings of these les, see Chapter 5.
System Configuration Error
The results of START/START.F are dierent from the real conguration. For example, Not
present is displayed for a system instrument when it is actually installed.
Possible Cause Solution
The HP-IB cables are not connected
properly.
Shut down the computer system, then turn the
system o. Conrm the HP-IB cable connections.
Errors during the PV4062/PV4062.F Program
Error occurs while Test Infomation of File is being Stored
As describ ed in Chapter 6, you sp ecify a le name in whichyou wanttosave the PV results.
For a new le, you enter test information, which will be the header information for the le.
If an error o ccurs while this information is being stored, the program ab orts and cannot be
continued.
Possible errors and their probable causes are listed as follo ws: where
xxxxx is the le name
that you sp ecied and yyyyy is a temp orary le name.
If an error o ccurs (program aborts), list the les that are on the data disk, then delete
temporary les ( TEMP001 , TEMP002 , and so on).
Can't create xxxxx .
Incorrect mass storage, or a write protected device is sp ecied. Or this error may occur
when reading a previously stored le, or if mass storage is full.
Can't output data to yyyyy .
Error when writing data to a temp orary le. Disk rejected.
Can't copy yyyyy to xxxxx .
Error when copying a temp orary le to a user specied le.
Can't purge yyyyy .
Error when purging temporary les.
Can't assign xxxxx ( yyyyy ).
The ASSIGN statement failed.
Error in copying data from yyyyy to xxxxx .
C-4 Installation Problems You May Encounter