Coupling
Fact;or
Function Group
Menu Map
Description
Programming Codes
See Also
ALC
1
This
softkey
allows specification of the coupling factor of an external
coupler/detector used to externally level the swept signal generator
output power. Negative coupling factor values are required for valid
entry. See “Specifications” for the coupling factor range.
SCPI: POWer:ALC:CFACtor
<num>[dB]]MAXimum]MINimum
Analyzer: NONE
(ALC)
“Externally Leveling the Swept Signal Generator” in Chapter 1
Function Group
FREQUENCY
Menu Map
2
Description
This
hardkey
lets you select a synthesized continuous wave frequency.
When you press
(cwl,
the swept signal generator stops sweeping
(green SWEEP LED off) and displays:
-->
CW:
XXXXX MHz,
where XXXXX represents a frequency value. Use either the rotary
knob, the step keys (with or without the left/right arrow keys), or
the numerical entry keys with a terminator key to set the desired
value. If a small change is desired, use the left and right arrow keys
to underline the digit to be changed.
Programming Codes
SCPI:
FREQuency[:CW] <num>[freq suffix] or
MAXimum]MINimum]UP]DOWN
FREQuency:MODE CW
Analyzer: CW
See Also
CW/CF
Coupled,(~],(~]
“CW Operation and Start/Stop Frequency Sweep” in Chapter 1
“Programming Typical Measurements” in Chapter 1
Operating and Programming Reference C-13
To Next Page
Loading...
