Using Step Sweep
1. Refer to menu map 2.
2. Press FREQUENCY
LMENU).
3.
Select Step Sap Menu.
4.
Select Step Size.
Enter the desired increment value.
5.
Select Step Points.
Enter the number of points desired.
6.
Determine the dwell time desired, select Step
swell
and enter
a value, or choose the dwell time determined by the ramp mode
sweep time, select Dwell Coupled .
7.
Determine the triggering scheme, select
Step Swp Pt Trig Auto ,
Bus,or
Ext
8. Press SWEEP
[MENU].
9.
Select Sweep Mode Step , to activate the step frequency mode.
Getting Started Advanced
l-5
1
To Next Page
Loading...
Need help?
General
