HP 8360 B Series User Manual

Disp Status
Table D-l.
Mnemonics used to indicate Status (continued)
Function
Mnemonic
Flatness On/Off
usrcorr
Start Sweep Trigger SwpTrig
Power Slope Rf Slope
Power Sweep
Pwr Swp
Sweep Mode SwpMode
Peak RF Always
AutoCal
AM BW Cal Always AutoCal
SwpSpan Cal Always AutoCal
State
Off
On
Automatic
HP-IB
External
Off
On
Off
On
Ramp
Step
List
cw
Span=0
On
On
On
Mnemonic
Off
On
Auto
BUS
Ext
Off
On
Off
On
Swept
Step
List
cw
Zero Span
Peaking or
Peak
AM BW or
AmBw or
Am
SweptFreq or
Freq or Frq
Programming Codes
SCPI: NONE
Analyzer: NONE
See Also
STATUS MESSAGES
Doubler Amp Mode AUTO
Function Group
POWER
Menu Map 5
Description
This softkey is applicable to instrument models with a doubler
installed. The doubler has an integral amplifier whose operation
is controlled by the instrument firmware. The use of the amplifier
depends on the frequency of operation and on the calibration
constants set at the factory. The instrument defaults after preset to
this automatic mode of operation which is the specified operation.
This softkey has no effect on instruments without a doubler.
An asterisk next to the key label indicates that this feature is active.
This feature is the default after preset.
D-8 Operating and Programming Reference

HP 8360 B Series Specifications

General

Brand	HP
Model	8360 B Series
Category	Portable Generator
Language	English