Programming Language CIIL
Description
Programming Codes
See Also
This softkey lets you select CIIL as the swept signal generator’s
external interface language. The use of this language requires the
M.A.T.E. option (Option 700) to be installed. Any commands issued
within 100 ms of a change in language may be ignored or lost. An
asterisk next to the key label indicates that this feature is active.
SCPI: SYSTem:LANGuage CIIL
Analyzer: CIIL
Adrs Menu
The M.A.T.E. option (Option 700) is documented in a separate
manual supplement called, HP 8360 Series Synthesized Sweepers
Option 700 Manual Supplement.
Programming
Language
SCPI
Function Group
Menu Map
Description
Programming Codes
See Also
SYSTEM
8
Standard Commands for Programmable Instruments (SCPI)
is the instrument control programming language adopted by
Hewlett-Packard. SCPI provides commands that are common
from one Hewlett-Packard product to another, eliminating “device
specific” commands.
This softkey lets you select SCPI as the swept signal generator’s
external interface language. This is the default language set at the
factory. Any commands issued within 100 ms of a change in language
may be ignored or lost. An asterisk next to the key label indicates
that this feature is active.
SCPI: SYSTem:LANGuage SCPI
Analyzer: SYST or SCPI
Adrs Menu, SCPI COMMAND SUMMARY, SCPI STATUS
REGISTER STRUCTURE
“Getting Started Programming” in Chapter 1
“Programming Typical Measurements” in Chapter 1
P-14 Operating and Programming Reference
To Next Page
Loading...
Need help?
General
