(ENTRYON/OFF]
Function Group
Menu Map
Description
Programming Codes
See Also
ENTRY
NONE
This
hardkey
lets you turn off (blank) the active entry area and
disable the ARROW keys, rotary knob, and entry keys. When
any function key (hard or soft) is pressed, the active entry area is
reactivated. The yellow LED, ENTRY ON, next to ENTRY ON/OFF)
indicates whether the entry area is active (LED on=active).
SCPI: No specific code activates (ENTRY ON/OFF)
Analyzer:EF=off
Arrow Keys
“Entry Area” in Chapter 1
Ext
Det
Cal
Function Group
USER CAL
Menu Map
9
Description
This softkey enables the swept signal generator to act as a controller
to an HP 437B power meter. This softkey causes an immediate
execute on the interface bus and generates an HP-IB error if no
power meter is present on the interface bus or if the swept signal
generator is unable to address the power meter. Use external
detector calibration to characterize and compensate for an external
negative diode detector used in an external leveling configuration.
Programming Codes
SCPI:
CALibration:PMETer:DETector:INITiate?
DIODe
CALibration:PMETer:DETector:NEXT?
<num>[lvl
suffix]
Analyzer:NONE
See Also
“Optimizing Swept Signal Generator Performance” in Chapter 1
E-6 Operating and Programming Reference
To Next Page
Loading...
Need help?
General
