Use of the Command Tables
In Table 1-4, notice that a new column titled “Allowed Values” has
been added to the command table. This column lists the specific
values or range of values allowed for each parameter. A vertical bar
(I)
separates values in a list from which you must choose one value.
The commands listed in the table are only part of all the available
SCPI commands of the swept signal generator. For a complete
listing of the programming codes see “SCPI Command Summary” in
Chapter 2, “Operating and Programming Reference”.
Table 1-4. Sample Swept Signal Generator Commands
Command
:ALibration
Parameters
Parameter Type
Allowed Values
:PMETer
:FLATness
:INITiate? flatness array
to cal
discrete
USER(DIODE]PMETer]MMHead
:NEXT?
ORRection
measured power
extended numeric
<num>
[lvl suffix]
:FLATness
REQuency
801
freq-
correction pairs
extended numeric
{
<num>
[freq suffix],
DB}2*801
:CENTer
[:CW]
:AUTO
center freq
CW freq
coupled to
center freq
extended numeric
extended numeric
Boolean
specified freq
range
~AXimum(MINimum]UP]DOWN
specified freq range
or
MAXimum]MINimum]UP]DOWN
ON]OFF]l]O
:MODE
:STARt
:STEP
free mode
start freq
discrete
extended numeric
CW]SWEep]LIST
specified freq range
or
MAXimum]MINimum]UP]DOWN
:AUTO
auto freq step
Boolean
[:INCRement] freq step
extended numeric
ON]OFF]l]O
20 to 0.01 dB or
MAXimum(MINimum
:STOP
stop freq
extended numeric
specified freq range
or
MAXimum]MINimum]UP]DOWN
ARKer[n]
[n] is 1 to 5, 1 is the
default
:FREQuency
marker frequency
extended numeric
specified freq range
or MAXimumjMINimum
l-88
Getting Started Programming
To Next Page
Loading...
