HP 8360 B Series User Manual

Select Power Sweep (asterisk on).
Press @YEi?).
The swept signal generator performs a power sweep beginning at
-20 dBm and ending at +5 dBm. The power meter indicates
+25 dB.
Power Slope Operation
This function allows for compensation of high frequency system or
cable losses by linearly increasing the power output as the frequency
increases. For this example, refer to the “Menu Map” section.
Press Power Slope,
the active entry area displays:
--> RF SLOPE:
X. XX dB/GHz, where X is a numeric value.
Power slope is now active, notice that an asterisk is next to the key
label.
Use the entry keys, rotary knob, or arrow keys to enter a value for
the linear slope.
Press Power Slope again to turn this feature off.
SUEPT SIGNAL
GENERflTOR
POWER tlETER
RF OUTPUT
POUER SENSOR
Figure l-10. Power Sweep and Power Slope Operation
Power Sweep
Power Slope
1. Press POWER INIENU).
1. Press POWER IFV1ENU_).
2. Select Power Sweep.
2. Select Power Slope.
3. Enter a value.
3. Enter a value.
4. Press terminator key.
4. Press terminator key.
Getting Started Basic 1-19

HP 8360 B Series Specifications

General

Brand	HP
Model	8360 B Series
Category	Portable Generator
Language	English