HP 8360 B Series User Manual

Hodule Menu
Module Menu
Function Group
Menu Map
1
Description
This softkey accesses the source module selection softkeys.
Millimeter-wave source modules can be connected to the swept signal
generator source module interface connectors (there is one each
on the front and rear panels). These softkeys give you the option
of letting the swept signal generator automatically look at both
connectors for source modules or telling the swept signal generator to
look only at the front or at the rear connector. You can also turn off
module sensing completely.
Programming Codes
See Also
(ALC)
Module Select AUTO
Sets the swept signal generator to
automatic selection of the source
module.
(Selects the front connector if source
modules are present at both front and
rear connectors.) This is the default
after preset.
Module Select Front
Sets the swept signal generator to select
the source module connected to the front
panel source module interface connector.
Module Select Rear
Sets the swept signal generator to select
the source module connected to the rear
panel source module interface connector.
Module Select None
Disables source module sensing.
SCPI: NONE
Analyzer: NONE
Softkeys listed above.
Operating and Programming Reference M-23

HP 8360 B Series Specifications

General

Brand	HP
Model	8360 B Series
Category	Portable Generator
Language	English