HP 8360 B Series User Manual

Measure Corr All
Markers All Off
Function Group
Menu Map
Description
Programming Codes
See Also
MARKER
3
This softkey lets you turn all the markers off. The frequency value
given to the markers remains in memory and will be recalled when
the marker softkeys are pressed again. Softkeys Amp1 Markers ,
Center=Marker , and Ml--M2 Sweep are not affected by turning the
markers off. The function (or the frequency values) is retained as the
swept signal generator settings.
SCPI: MARKer:AOFF
Analyzer: SHMO
Amp1 Markers ,
Center=Marker, Ml--M2 Sweep,@%?'ii?)
“Marker Operation” in Chapter 1
“Programming Typical Measurements” in Chapter 1
Measure Corr All
Function Group
Menu Map
Description
Programming Codes
See Also
POWER
5
This softkey enables the swept signal generator to act as a controller
to command an HP 437B power meter to measure flatness correction
values at all frequency points defined in the flatness array.
SCPI: NONE
Analyzer: NONE
Fltness Menu, Mtr Meas Menu
“Creating and Applying the User Flatness Correction Array” in
Chapter 1
Operating and Programming Reference M-7

HP 8360 B Series Specifications

General

Brand	HP
Model	8360 B Series
Category	Portable Generator
Language	English