Enter
Corr
Function Group
POWER
Menu Map
5
Description
This
softkey
lets you enter a power correction value for a frequency
point in the flatness array. A frequency point must be entered before
a correction value can be accepted, otherwise the following error
message appears:
ERROR
-
Must first enter correction freq.
The up/down arrow keys let you scroll through the frequency points
available for power correction. If no correction value is entered
for a frequency point, the swept signal generator display indicates
Undefined. The range of acceptable values is -40 to
+40
dB. An
asterisk next to the key label indicates that this feature is active.
Programming Codes
SCPI: NONE, see Fltness Menu
Analyzer: NONE
See Also
Fltness Menu
“Optimizing Swept Signal Generator Performance” in Chapter
1
E-2 Operating and Programming Reference
To Next Page
Loading...
