HP 8360 B Series User Manual

POWER (MENU_)
Programming Codes
SCPI: POWer[:LEVEL] <num>[lvl suffix] or
MAXimum]MINimum]UP]DOWN
Analyzer: PL
See Also a), CONNECTORS, Det Cal Menu, (FLTNESS ON/OFF),
Set Atten, Tracking Menu, Uncoupl Atten
“Programming Typical Measurements” in Chapter 1
POWER
(i+
Function Group
POWER
Menu Map 5
Description
This hardkey accesses the power function softkeys.
Fltness Menu
Accesses the softkeys in the flatness
correction menu.
Power Offset
Changes the displayed power to include
an offset, but does not change the
output power of the swept signal
generator.
Power Slope
Activates the linear, power-per-frequency
mode of power output, and makes RF
slope (dB/GHz) the active function.
Power Sweep
Activates power sweep mode and makes
power sweep (dB/swp) the active
function.
Set Atten
Activates uncoupled attenuator as
the mode of operation and makes the
attenuator value the active function.
Tracking Menu
Accesses the softkeys in the tracking
calibration menu.
Uncoupl Atten
Uncouples the attenuator from the ALC
system.
Up/Dn Power
Allows you to enter values for the power
level step size.
All RF power functions except for power level, flatness on/off, and
RF on/off are contained in the power menu.
Operating and Programming Reference P-5

HP 8360 B Series Specifications

General

Brand	HP
Model	8360 B Series
Category	Portable Generator
Language	English